Image default
Power System Uncategorized

Induction Type Overcurrent Relay,Non Directional Relay

Induction Type Overcurrent Relay

It is also known as Non Directional Relay.This type of relay works on the induction principle and initiates corrective measures when current in the circuit exceeds the predetermined value. The actuating source is a current in the circuit supplied to the relay from a current transformer. These relays are used on a.c. circuits only and can operate for fault current flow in either direction.

Constructional details.

Fig 1 : constructional details of a typical nondirectional induction type overcurrent relay.

Fig.1. shows the important constructional details of a typical non-directional induction type overcurrent relay. It consists of a metallic (aluminium) disc which is free to rotate in-between the poles of two electromagnets. The upper electromagnet has a primary and a secondary winding. The primary is connected to the secondary of a C.T. in the line to be protected and is tapped at intervals. The tappings are connected to a plug-setting bridge by which the number of active turns on the relay operating coil can be varied, thereby giving the desired current setting. The secondary winding is energized by induction from primary and is connected in series with the winding on the lower magnet. The controlling torque is provided by a spiral spring. The spindle of the disc carries a moving contact which bridges two fixed contacts (connected to trip circuit) when the disc rotates through a pre-set angle. This angle can be adjusted to any value between 0o and 360o. By adjusting this angle, the travel of the moving contact can be adjusted and hence the relay can be given any desired time setting.

Operation.

The driving torque on the aluminium disc is set up due to the induction principle as discussed .This torque is opposed by the restraining torque provided by the spring. Under normal operating conditions, restraining torque is greater than the driving torque produced by the relay coil current. Therefore, the aluminium disc remains stationary. However, if the current in the protected circuit exceeds the pre-set value, the driving torque becomes greater than the restraining torque. Consequently, the disc rotates and the moving contact bridges the fixed contacts when the disc has rotated through a pre-set angle. The trip circuit operates the circuit breaker which isolates the faulty section.

Related posts

Explaination of Electromagnetic attraction relays and their types

LearnNew

Distribution system and their classification

LearnNew

Applications of power electronics

Yusuf Faridi

Leave a Comment